Category: EE MCQ PDF
1) The identification of a two stroke engine is given by a. Cooling system b. Lubrication system c. Absence of valve d. All of these ANSWER: Absence of valve 2) Maximum …
1) What percent of installed capacity of gas turbines contribute to the total installed capacity of the power plants in India? a. 5 % b. 8 % c. 11 % …
1) Turbo alternators run at speeds a. Constant speed of 3000 rpm. b. Constant speed of 1000 rpm. c. A variable speed of above 1000 rpm. d. None of the …
1) The most suitable location for the power factor improvement device is a. Near the electrical appliance which is responsible for the poor power factor. b. At the sending end. …
1) What is demand factor? a. Average load to maximum demand. b. Maximum demand to connected load. c. Connected load to maximum demand. d. Maximum demand to average load. ANSWER: …
1) The potential of developing tidal power in India is in a. Kutch b. Ran c. San joe d. Severn ANSWER: Kutch 2) Pugga valley in Ladakh is suitable for which …
1.The temperature, under thermal and electrical system analogy, is considered analogous to (a) voltage (b) current (c) capacitance (d) charge (e) none of the above Ans: a 2.In electrical-pneumatic …
1) Capacitance between the two conductors of a single phase two wire line is 0.5 μ F/km. What is the value of capacitance of each conductor to neutral? a. 0.5 …
1) What is the purpose of bedding on the underground cables? a. To avoid leakage of current. b. To protect the sheath against corrosion. c. To protect the sheath from …
1) What is the safety factor of an insulator? a. Puncture strength * Flash over voltage b. Puncture strength / Flash over voltage c. Flash over voltage / Puncture strength …
