ONLINE MCQ EE AND ECE-CONTROL SYSTEMS 7

1. Proportional band of a controller is defined as the range of:
a) Measured variable to the set variable
b) Air output as the measured variable varies from maximum to minimum
c) Measured variables through which the air output varies from maximum to minimum
d) None of the above

 Answer  

2. Proportional band of the controller is expressed as:
a) Gain
b) Ratio
c) Percentage
d) Range of control variables
 

Answer  

3. The term reset control refers to:
a) Proportional
b) Integral
c) Derivative
d) None of the above
 

Answer  

4. The integral control:
a) Increases the steady state error
b) Decreases the steady state error
c) Increases the noise and stability
d) Decreases the damping coefficient

Answer  

5. In a proportional temperature controller, if the quantity under the heater increases the offset will:
a) Increase
b) Reduce
c) Remain unaffected
d) None of the above
 

Answer  

6. When derivative action is included in a proportional controller, the proportional band:
a) Increases
b) Reduces
c) Remains unchanged
d) None of the above

Answer  

7. The number of operational amplifiers require for designing of electronic PID controller is:
a) 1
b) 2
c) 3
d) 6

Answer  

8. Which of the following system provides excellent transient and steady state response:
a) Proportional action
b) Proportional + Integral action
c) Proportional + Differential action
d) Proportional + Integral + Differential action

Answer  

9. In a PID controller, the offset has increased. The integral time constant has to be ___ so as to reduce offset:
a) Reduced
b) Increased
c) Reduced to zero
d) None of the above
 

Answer  

10. In a PID controller, the overshoots has increased. The derivative time constant has to be __ so as to reduce the overshoots:
a) Increased
b) Reduced
c) Reduced to zero
d) None of the above

Answer

ONLINE MCQ EE AND ECE-CONTROL SYSTEMS 8
EE AND ECE SHORT NOTES-Measurement and Instrumentation 1

Leave a Reply