ONLINE MCQ EE-TRANSFORMER PART NINE

[1] A Buchholz relay can be installed on
A. Auto-transformers
B. Air-cooled transformers
C. Welding transformers
D. Oil cooled transformers

Answer  

[2] The chemical used in breather is
A. Asbestos fibre
B. Silica sand
C. Sodium chloride
D. Silica gel

Answer  

[3] Material used for construction of transformer core is usually
A. 0.4mm to 0.5 mm
B. 4mm to 5 mm
C. 14mm to 15 mm
D. 25mm to 40 mm

Answer  

[4] Helical coils can be used on
A. Low voltage side of high kVA transformers
B. High frequency transformers
C. High voltage side of small capacity transformers
D. High voltage side of high kVA rating transformers

Answer  

[5] The transformer ratings are usually expressed in terms of
A. Volts
B. Amperes
C. kW
D. kVA

Answer  

[6] The value of flux involved in the emf equation of a transformer is
A. RMS value
B. RMS value
C. Maximum value
D. Instantaneous value

Answer  

[7] The main advantage of auto transformer over a two winding transformer is
A. Hysteresis losses are reduced
B. Saving in winding material
C. Copper losses are negligible
D. Eddy losses are totally eliminated

Answer  

[8] During short circuit test iron losses are negligible because
A. The current on secondary side is negligible
B. The voltage on secondary side does not vary
C. The voltage applied on primary side is low
D. Full-load current is not supplied to the transformer

Answer  

[9] Which of the following properties is not necessarily desirable in the material for transformer core?
A. Mechanical strength
B. Low hysteresis loss
C. High thermal conductivity
D. High permeability

Answer  

[10] The main reason for generation of harmonics in a transformer could be
A. Fluctuating load
B. Poor insulation
C. Mechanical vibrations
D. Saturation of core

Answer

ONLINE MCQ EE-TRANSFORMER PART TEN
ONLINE MCQ EE-TRANSFORMER PART EIGHT

Leave a Reply