a) Are parallel to one another

b) Intersect at 45 deg

c) Intersect at 30 deg

d) Are orthogonal

Answer

[2]

For a pulse transformer, the material used for its core and the

possible turn ratio from primay to secondary are respectively

(a) ferrite; 20:1

(b) laminated iron; 1:1

(c) ferrite; 1:1

(d) powdered iron; 1:1

Answer

[3] The capacitance of a reverse biased junction of a thyristor is 20

picofarad. The charging current of this thyristor is 4mA. The limiting

value

of dv/dt is …..V/uS

Answer

[4] When the induction motor runs at synchronous speed the voltage induced in the rotor of it is

(a) Very near input voltage to stator

(b) Slip time the input voltage

(c) Zero

(d) None of the above

Answer

[5] Chopper control for the DC motor provides variation in

(a) Input voltage

(b) Frequency

(c) None of the above

Answer

[6] While comparing SCR with BJT, which of the following is true

(a) SCR requires turn off circuit while BJT does not

(b) The voltage drop of SCR is less than BJT

(c) SCR requires a continuous gate current

(d) BJT draws continuously base current

Which of the above statements are true?

(1) a only

(2) d only

(3) a, d

(4) b, d

Common Data Questions: 7 & 8** **

In

the 3-phase inverter circuit shown, the load is balanced and the gating

scheme is 180°-conduction mode.All the switching devices are ideal

Answer

[7] The rms value of load phase voltage is [GATE2012]

Answer

[8] If the dc bus voltage Vd=300V, the power consumed by 3-phase load is [GATE2012]

Answer

[9] The typical ratio of latching current to holding current in a 20A thyristor is [GATE 2012]

Answer

[10] A half-controlled single-phase bridge rectifier is supplying an R-L

load. It is operated at a firing angle α and the

load current is continuous. The fraction of cycle that the

freewheeling diode conducts is [GATE 2012]

Answer

[11] For power factor correction of power systems which one is used:

(a) capacitor

(b) inductor

(c) resistors

Answer

[12] Which type of motor used in home ceiling fan:

(a) capacitor motor

(b) shaded pole motor

(c) universal motor

(d) split phase capacitor motor

Answer

[13] Op-amp (operational amplifier) input resistance:

(a) Zero

(b) Infinity

(c) Relative resistance

(d) Same output resistance

Answer

[14] For an inverter op-amp, what will be the equivalent output resistance?

(a) Zero

(b) Infinity

(c) Relative forward resistance

(d) Same as the input resistance

Answer