ONLINE MCQ EE-BASIC ELECTRICAL PART 10

[1] Suppose Double the voltage in a simple dc circuit and cut
the resistance in half , then the current will
(a) Become four times as great
(b) Become twice as great
(c) Stay the same as it was before
(d) Become half as great

Answer

[2] If four resistors are connected in series, each with a
value of 4Kohm, the total resistance is

(a) 1kΩ
(b) 4 kΩ
(c) 8 kΩ
(d) 16 kΩ

Answer
[3] Three resistors each with a value of 0.069M ohm are in
parallel. The total resistance is

(a) 23 Ω
(b) 23 KΩ
(c) 204 Ω
(d) 0.2 mΩ

Answer

[4] Proper biasing in
an amplifier circuit

(a) Causes it to
oscillate
(b) Prevents an
impedance match
(c) Can be obtained
using a voltage divider network
(d) Maximizes current
flow

Answer

[5] A transistor can
be protected from needless overheating by

(a) A current-limiting
resistor
(b) Bleeder resistors
(c) Maximizing the drive
(d) Shorting out the
power supply when the circuit is off

Answer

[6] A bleeder resistor

(a) Is connected across
the capacitor in a power supply
(b) Keeps a transistor
from drawing too much current
(c) Prevents an
amplifier from being over driven
(d) Optimizes the efficiency
of an amplifier

Answer

[7] An advantage of
rheostat over a potentiometer is

(a) Rheostat can handle
higher frequencies
(b) Rheostat is more
precise
(c) Rheostat can handle
more current
(d) Rheostat works
better with dc

Answer

[8] The average power delivered to an impedance (4 – j3)Ω  by a current 5cos(100πt + 100π)A is [GATE 2012]

(a)  44.2W
(b)  50W
(c)  62.5W
(d) 125W

Answer
[9]
A periodic voltage waveform observed on an oscilloscope across a load
is shown. A permanent magnet moving coil (PMMC) meter connected across
the same load reads [GATE 2012]

(a) 4 V
(b) 5 V
(c) 8 V
(d) 10 V

Answer
[10]The bridge method commonly used for finding mutual inductance is 

[GATE 2012]

(a) Heaviside Campbell bridge
(b) Schering bridge
(c) De Sauty bridge
(d) Wien bridge

Answer
Solution Hint: Heaviside-campbell equal ratio bridge is used for measuring self-inductance in terms of mutual inductance.
Schering bridge = used for measuring capacitance and dielectric loss of a capacitor.
De Sauty bridge = used for comparing the capacitances of two capacitors.
Wien bridge = used for audio-frequency measurement of capacitors over a wide range. 

[11] An ideal voltage source will charge an ideal capacitor[Gate 1997]

(a) In infinite time
(b) Exponentially
(c) Instantaneously
(d) None of the above

Answer

[12] A practical current source is usually represented by[Gate 1997]
(a) A resistance in series with an ideal current source
(b) A resistance in parallel with an ideal current source
(c) A resistance in parallel with an ideal voltage source
(d) None of the above

Answer

[13] Energy stored in a capacitor over a cycle, when excited by an ac source is[Gate 1997]
(a) The same as that due to a dc source of equivalent magnitude
(b) Half of that due to a dc source of equivalent magnitude
(c) Zero
(d) None of the above

Answer

[14] A major advantage of the active filters is that they can be realized without using[Gate 1997]

(a) Opamps
(b) Inductors
(c) Resistors
(d) Capacitors

Answer

[15] The computer program which converts statements written in high
level language to object code is  known as [Gate 1997]
(a) Assembler
(b) Operating system
(c) Object oriented software
(d) None of the above

Answer

ONLINE MCQ EE-BASIC ELECTRICAL PART 10
CURRENT AFFAIRS UPDATE FOR UPPCL AE EE RE-EXAM

Leave a Reply