ONLINE MCQ EE AND ECE-Measurements and Instrumentation Part 6

[1] The most preferred material for the control spring is
(a) German silver
(b) Platinum silver
(c) Silicon bronze
(d) Phosphor bronze

Answer
[2] A moving coil instrument is used as an ohmmeter. The indicating scale of the meter will be
(a) Hyperbolic
(b) Logarithmic
(c) Linear
(d) Inverse linear

Answer
[3] For high accuracy the meter has
(a) Supporting mirror
(b) Hand drawn scale
(c) Printed scale
(d) Scale with sharp pointer

Answer
[4] Among the voltages to various electrodes in a CRT the voltage is the highest on
(a) Aquadag
(b) Focusing anode
(c) Deflection plates
(d) PD anode

Answer
[5] In a free running oscilloscope the horizontal deflection system is driven by a …….. waveform
(a) Step
(b) Impulse
(c) Ramp
(d) DC

Answer
[6] A Lissajous patterns are used to measure
(a) Voltage and frequency
(b) Frequency and Phase shift
(c)  Frequency and amplitude distortion
(d) Amplitude and flux

Answer
[7] The shunt used in milliammeter
(a) will extend the range and reduce the meter resistance
(b) will extend the range and increase the meter resistance
(c) will decrease the range and meter resistance
(d) will not affect the meter

Answer
[8] The electrostatic instruments can be used without serious loss of accuracy upto ……… frequency
(a) 100Hz
(b) 100kHz
(c) 1 MHz
(d) 10MHz

Answer
[9] In the case of PMMC rectifier type instruments, the deflecting torque is proportional to
(a) Average value of AC current
(b) RMS of AC
(c) Instantaneous value
(d) Peak value

Answer
[10] Inductance and capacitance in the electrostatic system of units has the dimensions of
(a) mass
(b) mass-time
(c) mass length/time
(d) length

Answer
[11] For the indicating instrument the preferred damping condition is
(a) Critically damped
(b) a damping coefficient of 0.8 to 1
(c) Overdamped
(d) Underdamped

Answer
[12] One international ohm is equal to
(a) 1.00049 absolute ohm
(b) 0.99951 absolute ohm
(c) 0.969 absolute ohm
(d) 1.049 absolute ohm

Answer

ONLINE MCQ EE AND ECE-Measurements and Instrumentation Part 7
ONLINE MCQ EE AND ECE-Measurements and Instrumentation Part 5

Leave a Reply