ONLINE MCQ EE AND ECE-Measurements and Instrumentation Part 10

[1] A hot-wire ammeter

A. Can measure ac as well as dc
B. Registers current changes very fast
C. Can indicate very low voltages
D. Measures electrical energy

Answer

[2] The device used to indicate the presence of an electric current is

A. Electrometer
B. Galvanometer
C. Voltmeter
D. Coulometer

Answer
[3] A watt-hour meter measures

A. Voltage
B. Current
C. Energy
D. Power

Answer

[4] A voltmeter should have

A. Low internal resistance
B. High internal resistance
C. Electrostatic plates
D. A sensitive amplifier

Answer

[5] An average-reading digital multimeter reads 10V when fed with a
triangular wave, symmetric about the time-axis.For the same input an
rms-reading meter will read  [GATE]

A. 20/√3
B. 10/√3
C. 20√3
D. 10√3

Answer

[6]
The figure shows a three-phase delta connected load supplied from a
400V,50Hz,3-phase balanced source. The pressure coil(PC) and current
coil(CC) of a wattmeter are connected to the load as shown,with the coil
polarities suitably selected to ensure a positive deflection. The
wattmeter reading will be   [GATE]

A. 0

B. 1600Watt
C. 800Watt
D. 400Watt

Answer

[7]
The probes of a non-isolated, two channel oscilloscope are clipped to
points A,B and C in the circuit of the adjacent figure. Vin is a square
wave of a suitable low frequency. The display on Ch1 and Ch2 are as
shown on the right. Then the “signal” and “ground” probes S1, G1 and S2,
G2 of Ch1 and Ch2 respectively are connected to points [GATE 2007]
A.  A, B, C, A
B.  A, B, C, B
C.  C, B, A, B
D.  B, A, B, C

Answer

[8] An analog voltmeter uses external multiplier settings. With a
multiplier setting of 20kΩ, it reads 440V and-with a multiplier setting
of 80kΩ it reads 352V. For a multiplier setting of 40kΩ,voltmeter
reads  [GATE2012]

A. 371V
B. 383V
C. 394V
D. 406V

Answer

[9] The rate at which charge carriers flow is measured in

A. Coulombs
B. Amperes
C. Watt-hour
D. Watts

Answer

[10] The main problem with bar-graph meters is that

A. They are not very sensitive
B. They are unstable
C. They cannot give very precise readings
D. They can display only peak values

Answer

[11] A dynamometer type wattmeter responds to the [Gate 1997]
(a) Average value of the active power
(b) Average value of reactive power
(c) Peak value of the active power
(d) Peak value of the reactive power

Answer

[12] A transfer instrument employed in the standardization of a polar type ac potentiometer is [Gate 1997]

(a) An electrostatic instrument
(b) A thermal instrument
(c) A dynamometer instrument
(d) A moving coil instrument

Answer

ONLINE MCQ EE AND ECE-Measurements and Instrumentation Part 11
IMPORTANT ELECTRICAL ENGINEERING UNITS

Leave a Reply